Table of Contents
Advertisement
13. FIRMWARE UPDATE
■ What is needed?
・ The supplied SD card containing the saved firmware file that may be downloaded at:
http://www.aorja.com/receivers/ar-dv10.html
If the receiver contains a large amount of scan and search data, it is advised to have at least
200MB free space on the card.
■ Words of caution!
・ The memory data and systems are very likely to be erased after a firmware update,
therefore it is always advised to first backup the receiver data as follows:
Press and hold the [●] button
Press [2]
Press [6] (Note: "SYSTEM" means a complete backup)
・ Beware, the backup files will always be saved back to the same names, therefore
previous back-up files will be overwritten without warning. Please move previous
back-up files to your PC.
・ Do not cut the power or remove the SD card while the firmware is being uploaded to the
receiver! This could potentially corrupt system data and make the receiver unusable.
Such a happening would not be covered by the manufacturer warranty.
・ The firmware is the property of AOR Ltd. and should not be re-distributed, either in its
original form or in any modified form.
・ AOR will issue firmware updates to fix major bugs and add new functions, whenever
required by our development plan. However, there is no guarantee updates will be made
available at regular intervals.
■ Update procedure
1.
The receiver must be OFF.
2.
Lift the rubber cover labeled MicroSD.
3.
Insert the SD card containing the update file (for
example 1801C.D10) into the receiver slot. Refer to
the illustration for the SD card's orientation.
4.
Switch the receiver ON.
Make sure there is enough battery power to complete the update. A power interruption
during the update procedure could potentially corrupt system data and make the
receiver unusable. Such a happening would not be covered by the manufacturer
warranty.
Wait until the boot procedure is complete and confirm that the SD card icon
on the right side of the LCD.
55
appears
Advertisement
Table of Contents
