Arrow Storage Products DKGA-A Owner's Manual And Assembly Manual page 20

Step 7: Roof Assembly
You will need for this page:
SS
(QTY: 24) (QTY: 8)
1
Attach the end of the rear Ridge Cap with two (2)
holes in existing Ridge Cap with two (2) Small
Bolts and Nuts.
2
Install Roof Panels.
3
Seal the ridge of the building with Weather
Stripping.
4
Where Panels overlap under Ridge Cap, secure
with two (2) Small Bolts and Nuts and seal with
a strip of tape.
Weather Stripping Tape should be applied in
a continuous strip along the length of the roof.
SB
Seal Ridge
Reused Parts:
• Roof Panel (2)
• Ridge Cap (1)
• Starting with rib #5 below, every rib that is over
a Truss should be secured with a Small Bolt and
Nut, and then sealed with a strip of Tape.
SB
20
4
5
Leave holes on ribs #1 and #2 open.
20AG
1
2
3