Advertisement
Step 6: End Panels
You will need for this page:
SS
(QTY: 6)
Secure the End Panel to the Main Roof
1
Beam by placing a Small Screw in hole
#1 (from the diagram below). Carefully
remove the Gable Edge Trim once the Panel is
in position.
2
Fasten Panel to Gable by placing Small
Bolts and Nuts through holes #2 - #7.
Fasten the holes in order.
Secure the Panel by placing a Small
3
Screw to the outer Roof Beam in hole #8
and Side Angle in hole #9. Repeat for other
End Panel.
FASTEN TO NEXT PANEL
1
LEAVE THIS HOLE OPEN
2
LEAVE THIS HOLE OPEN
3
4
8
5
6
7
9
LEAVE THESE HOLES OPEN
SB
(QTY: 12)
Nut
Washer
GABLE
Reused Parts:
•
Right Roof End Panel (1)
•
Left Roof End Panel (1)
An Awl may be used to help
align holes that are only slightly
misaligned. Take care not to bend
or warp the metal, and always practice
proper tool safety.
Bolt
19
If Roof Beam holes do not line up with
Roof Panel holes, shift the building from
left to right. If this does not help, your
building may not be level. Shim the
corners until holes line up.
1
2
8
3
4
Work one corner at a time. Be sure
to fi nish a corner before moving on to
the next one.
19AG
5
9
6
7
Advertisement
