Advertisement
Step 3:
You will need for this page:
LS
LS
(QTY: 2)
(QTY: 6)
SS
(QTY: 6)
LS
LS
LS
LS
Carefully
position
1
Rear Wall Assembly as shown
and secure with four (4) Large
Screws on both sides to Floor Frame
and Side Angle. Reuse Side Wall
Channels from original unit and attach
using four (4) Large Screws as shown.
2
Position the Door Jambs as
shown and secure to the Front
Wall Panel using Small Screws.
Double check that the holes in the Door
Jamb line up with the holes in the Wall
Post (Hinge). If they do not, the Left
and Right Door Jambs are most likely
switched.
New Rear Wall Install
1
10622
80037
Right Door
Jamb
LS
LS
the
New
SS
SS
80037
SS
Assemblies from Step 2:
1
•
New Rear Wall Assembly
Reused Parts:
Left Door
•
Side Wall Channel (2)
Jamb
LS
LS
LS
IMPORTANT: When installing
the Front Wall Assembly in
the building, two (2) people
should position and hold the
Assembly in place until it is
secure. Failure to do so could
result in bending the Front
Frame and Fascia pieces.
12
Side Wall Channel will attach
behind Wall and Corner Panels.
10622
12AG
Advertisement
