YASKAWA V7 Technical Manual page 100

5.29 COPY FUNCTION
B. Copy Function (Cpy)
The Copy function writes the parameters stored in the digital operator's EEPROM into the drives non-volatile memory. The
Copy function is possible only for drives of the same type (i.e. from one GPD 315/V7 to another), voltage rating, and con-
trol method (V/f or open loop vector).
DESCRIPTION
Set the highest parameter
access level.
This will allow all parameters
to be viewed and set.
Set Parameter Copy
Access Selection (n177) = 1
Execute upload (Copy)
Using Copy Function
Selection (n176)
Continued
Table 5-6. Writing Drive Parameters
KEY SEQUENCE
DSPL
Press the key until the
is lit on the digital operator.
DATA
ENTER
Press .
V
Press three times.
DATA
ENTER
Press .
V
Press and hold until n177 is
displayed on the digital operator.
DATA
ENTER
Then press .
V
Use the key to set a "1" in the
display.
DATA
ENTER
Then press .
V
Press the key once.
DATA
ENTER
Then press .
V
Press the key twice.
DATA
ENTER
Press . "CPY" will blink on the
display while writing.
5-48
DIGITAL OPERATOR
PRGM
LED
DISPLAY
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM