Raymarine Marine GPS System User Manual page 169

Connecting Directly to Radar
In order for Navigator to be able to display range rings, cursor infor-
mation, and electronic bearing lines, the radar system you use must be
able to output the NMEA RSD string.
To display MARPA targets, your radar must be able to output NMEA
TLL or TTM strings. If you are going to this feature, make sure your
radar system is correctly tracking the MARPA targets before connect-
ing it to Navigator.
To connect directly to radar, refer to Figure A-1 and Table A-3.
Table A-3. Connecting Navigator Directly to Radar System
Connect Cable Color:
Yellow (Rx)
Blue (SGnd)
Green (Tx)
Black (SGnd)
Appendix A – Connecting Peripheral Instruments
To Radar Lead:
NMEA + output
(which may also be labeled TX, TX+,
Data Out+, or NMEA OUT+)
Not used
Not used
NMEA - output
(which may also be labeled TX-,
Data Out -, or NMEA OUT-, or Ground)
A-5