Table of Contents
Advertisement
Adjusting Display Gain (Sensitivity)
Split Frequency – The transducer can operate in both 50 kHz and 200
kHz frequencies at the same time. If you choose split frequency
operation, the scrolling bottom display is split horizontally; the upper
half shows the 200 kHz detailed view and the lower half shows the 50
kHz image. You can also choose the split frequency display with the
Fishfinder display options: Bottom Lock, A-Scope, or Zoom.
To change the frequency:
1.
From the Functionbar's top-level menu, click
2.
Click
50 KHz
displayed in the selected frequency. If you choose split,
the scrolling bottom is dis-played in both frequencies with
200 kHz in the upper and 50 kHz in the lower window.
3.
If necessary, click
automatic and manual frequency selection.
4.
Click
ENTER
Functionbar menu.
The Gain, or sensitivity, of the display adjusts background noise by
varying echo strength for display. The value of the GAIN control
determines the strength above which echoes are displayed: If the Gain
is low only the strongest echoes are displayed; as the gain is increased
more, but weaker echoes (from, say air bubbles) are displayed.
The display Gain should be set high enough to see fish and bottom
detail, but without too much background noise. Generally, a high gain
is used in deep/clear water; a low gain in shallow/murky water.
The Fishfinder provides automatic or manual Gain adjustment.
Automatic adjustment is based on depth and water conditions. As
conditions change the auto-gain adjusts to display fish with a
minimum of background noise. You can manually add a bias to the
auto-gain setting. If you select manual adjustment, you will need to
re-adjust the Gain as conditions change.
Advanced Navigator Functions
,
or
. The scrolling bottom is
200 KHz
Split
Frequency/Auto
,
, or
to return to the top-level
CLEAR
BACK
Frequency
to toggle between
5-41
.
Advertisement
Table of Contents
