Raymarine Marine GPS System User Manual page 114

Measuring Range and Bearing to Target from Vessel
Using VRM/EBL
To measure the range and/or bearing of a target or point from your
vessels position, you need to place a VRM/EBL and move it so that it
crosses the target or point for which you require the bearing or range.
When you turn on a VRM/EBL, it is displayed in its last-used
position.
Note: If the VRMs last-used position is outside the radar
picture at the current range setting, it is placed at its
default position instead. This is one third of the range
for VRM1, and two-thirds for VRM2.
To access VRM/EBLs:
1. Click the
The VRM/EBL buttons are displayed.
2. Click the button that corresponds with the action you want:
Click:
VRM/EBL On/Off
Edit VRM/EBL
Edit VRM
Edit EBL
Databox On/Off
3. Click Databox On/Off
VRM/EBL button on the Pathfinder Panel.
Display VRM/EBL in its last-used
position/Remove the VRM/EBL
from the radar display.
Modify the selected
VRM/EBL combination.
Modify the selected VRM.
Modify the selected EBL.
Display/Remove Databox.
to display range and bearing.
Advanced Navigator Functions
To:
5-23