Canon imageFORMULA DR-X10C Service Manual page 185

3) Status
Check the state of the imprinter. The mark
of each item lights according to its state.
Mark Sensor name/lighting state
Busy
Lights during normal operation.
However, it does not light in ser-
vice mode.
Head
Lights when the ink cartridge is
installed.
Move
Lights when the cartridge unit is
moved during opening or closing
the cover.
Home
Lights when the machine is nor-
mal.
Move error
Lights when a motor or sensor
error occurs.
Voltage error
Lights when the applied voltage is
abnormal.
Mask
Lights when the cartridge is in the
non-printing area.
Communication error
Lights when a data communication
error occurs or the PCB failure is
defective.
Table 5-312
COPYRIGHT © CANON ELECTRONICS INC. 2008
i. Patchcode
1) Set a sheet of paper on which a patchcode
2) Select setting items of [Speed] and [Ori-
3) Select the [START] button. The pickup tray
4) The results are displayed.
CANON DR-X10C FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
The operation check of the patchcode de-
coder is performed in this mode. When the
[Patchcode] tab is selected, a screen is
displayed.
Figure 5-328
Operation Procedure
is printed on the pickup tray. The patchcode
should be on the top surface.
entation] from the pulldown boxes.
Figure 5-329
lifts and the paper is fed and ejected onto
the eject tray.
Figure 5-330
5-23