Canon imageFORMULA DR-X10C Service Manual page 180

CHAPTER 5 TROUBLESHOOTING
e. Motor, clutch
Check the operation of the motor and
clutch. The list below shows target parts.
Display
Pick Motor Pickup motor
Feed Motor Feed motor
Feed roller
Reverse roller
Separate Separation motor
Motor
Eject Motor Eject motor
Clutch Front Magnetic clutch (front)
Registration roller
Clutch Rear Magnetic clutch (rear)
Reading roller (front)
Tray Motor Tray motor
Pickup tray up/down
Blower Top Blower of the reading unit
(upper)
Blower Blower of the reading unit
Bottom (lower)
Fan Exhaust fan
Image Unit Shading motor
CIS unit position
Black White Platen motor
Background
Panel Pickup up/down motor
Pick Up Down Reverse up/down motor
Table 5-311
The following describes the operation
method and selection items by type.
5-18
Target name
COPYRIGHT © CANON ELECTRONICS INC. 2008
1) Pick/Feed/Main/Separate Motor
When the [On] button on the right side is
selected first, and then conditions are se-
lected from the [Speed] and [Direction]
pulldown boxes, the motor runs accord-
ingly.
However, conditions that do not match each
motor are not displayed.
When [Stop] on the pulldown box is se-
lected or the [On] button is selected again,
the motor stops.
The figure below shows each selection
screen.
Pick Motor
Feed Motor
Main Motor
Separate Motor
Figure 5-316
2) Others
When conditions are selected from the
pulldown box, the motor or clutch is driven
accordingly.
The figure below shows each selection
screen.
CANON DR-X10C FIRST EDITION