F146 Recv] Data Reception (Mewtocol-Com Master) - Panasonic FP0H User Manual

Instruction References

8.2.3 [F146 RECV] Data Reception (MEWTOCOL-COM Master)

 Instruction format
R0
 Devices that can be specified (indicated by ●)
Oper-
WX WY
ands
S1 ● ●
S2 ● ●
n ●
D ●
(*1): A character constant cannot be specified.
 Operands
Operands Settings
Specify the starting number of the area (2 words) that stores control data.
S1
S1
S1+1
Specification of
S2
a destination unit
Specification of
n
a destination unit
Specification of
D
a master unit
(Note 1): To [S1], the following specification should be applied. The specification method differs depending on word
transfer and bit transfer.
[S1]：
H0
Transfer in
Specify the number of send words
word units H001 to H1FD (1 to 509 words)
[S1]：
H8
Transfer in
Destination bit No.
bit units
(H0 to HF)
(Note 2): To [S1+1], the following specification should be applied. When the COM port No. is 0, specify HF for the
highest digit.
[S1+1]：
H0 (fixed)
Select a COM port
(H1/H2/HF)
8-6
F146 RECV
WR WL SV EV
● ● ● ●
● ● ● ●
● ● ● ●
● ● ● ●
Specify the transfer method.
Word transfer: Specify the number of send words.
Bit transfer: Specify the bit number of a master unit and that of a
destination unit.
Specify the COM port No. of a master unit and the unit number of
a destination unit.
Specify the source data area of a destination unit.
(Device No. is fixed to "0")
Specify the starting address of the device in the
source data area of a destination unit.
Specify the device starting address of the receive
data storage area in the master unit.
H0 (fixed)
Destination unit bit No.
(H0 to HF)
Unit No. (H01 to H63)
(1 to 99)
DT10 DT0 K100
S1 S2
DT LD In SWR SDT
● ● ●
● ●
● ●
● ●
DT50
n D
Constant Index
modifier
K H
(*1)
●
● ●
Setting range
(Note 1)
(Note 2)
●
●
●