Panasonic FP0H User Manual page 5

3. Setting and Confirmation of Communication Conditions3-1
3.1 Setting of Purpose and Communication Conditions .............................. 3-2
3.1.1 Purpose to be Set for Each Port ............................................................. 3-2
3.1.2 Communication Conditions to be Set for Each Port ................................ 3-2
3.2 Communication Conditions Settings ...................................................... 3-3
3.2.1 System Register Settings ........................................................................ 3-3
3.2.2 Settings Using a Program ....................................................................... 3-4
4. PLC link ............................................................................... 4-1
4.1 Operation of PLC Link MEWNET-W0 .................................................... 4-2
4.1.1 Operation Overview of PLC Link ............................................................. 4-2
4.1.2 Roles of Link Relays and Link Registers ................................................ 4-3
4.2 Setting Items for PLC Link .................................................................... 4-4
4.2.1 Unit Number Setting ................................................................................ 4-4
4.2.2 Setting of the Largest Unit Number ......................................................... 4-4
4.2.3 Memory Block No. of Link Relays and Link Registers to be Used .......... 4-5
4.2.4 Ranges of Link Relays and Link Registers to be Used ........................... 4-5
4.2.5 Link Relay Transmission Start Number and Sending Size ..................... 4-6
4.2.6 Link Register Transmission Start Number and Sending Size ................. 4-7
4.3 Response Time of PLC Link .................................................................. 4-9
4.3.1 Response Time of One Transmission Cycle ........................................... 4-9
4.3.2 Response Time when There are Units that have not been Added to the
Link ........................................................................................................ 4-11
5. MEWTOCOL Master-Slave Communication ..................... 5-1
5.1 List of MEWTOCOL Supported Commands .......................................... 5-3
5.1.1 List of MEWTOCOL Commands ............................................................. 5-3
5.2 MEWTOCOL-COM Master Communication (RECV) ............................ 5-4
5.3 MEWTOCOL-COM Master Communication (SEND) ............................ 5-6
Table of Contents
iii