Wiring Method - Panasonic FP0H User Manual

2.2.3 Wiring Method

 Wiring method
(1) Remove a portion of the wire's insulation.
(2) Insert wire into terminal hole until it stops. Tighten screw clockwise to fix wire in place.
(Tightening torque: 0.22 N･m to 0.25 N･m (2.3 kgf･cm to 2.5 kgf･cm)
 Precautions on wiring
The following precautions should be observed to avoid broken or disconnected wires.
• When removing the wire's insulation, be careful not to scratch the core wire.
• Do not twist the core wires to connect them.
• Do not solder the core wires to connect them. The solder may break due to vibration.
• After wiring, make sure stress is not applied to the wire.
• In the terminal block socket construction, if the wire is fastened upon counter-clockwise
rotation of the screw, the connection is faulty. Disconnect the wire, check the terminal hole,
and then re-connect the wire.
• If two wires are connected to the RS-485 terminal, use the same wire material of the same
cross-sectional area (0.5 mm
2.2 Wiring of the COM Port Terminal Block
2
).
2-5