YASKAWA DX200 Instructions Manual page 27

6 Connection
As illustrated in the figure below, Connect the intrinsically safe cable to the terminal of the
relay barrier (3BAR) and the terminal of the isolated barrier (4BAR) in the painting unit.
2. For grounding the intrinsically safe cables, that are to be connected to (3BAR) and (4BAR),
open the back panel of the painting unit, and then connect the grounding cables to the
terminals.
3.
External Motor
Unit
Pressure Switch Unit
Intrinsically safety
terminal block
P1
N1
P3
N3
1
2
Grounding terminal part
DX200
Painting Unit
Relay barrier
(6BAR)
P1
N1
P3
N3
Isolated Barrier
(7BAR)
1
2
Intrinsically Safety cable
Back side panel
6-8
(*1)
The content described in this diagram is a
representative example, and it is subject to
change depending on the specifications.
(*2)
Crimped terminal shown below is
recommended for connecting the relay
barrier(6BAR) inside the DX200
1.25-MS3(J.S.T. CONNECTORS)
(*3)
Crimped terminal shown below is
recommended for connecting the Isolated
barrier(7BAR) inside the DX200
(J.S.T. CONNECTORS)
1.25-AF2.3B
.
HW1483325
174117-1CD
27/33