Pan/Tilt/Zoom; Display - Q-See QC40198 User Manual

MAIN MENU

5.3.8 Pan/Tilt/Zoom

The pan/tilt/zoom setup includes the following items. Please select channel first. See Figure 5-22.

Protocol: Select corresponding PTZ protocol such as PELCOD.

Address: input corresponding PTZ address.

Baud rate: Select baud rate.

Data bit: Select data bit.

Stop bit: Select stop bit.

Parity: There are three choices: none/odd/even.
After completing the setup click save button, system goes back to the previous menu.
For detailed setup, please refer to Chapter 4.9 preset/patrol/pattern/scan.

5.3.9 Display

Display setup interface is shown below. See Figure 5-23.

Transparency: Here you can adjust transparency. The value ranges from 128 to 255.

Channel name: Here you can modify channel name. System supports up to 25-digits. Please note all your
modifications here only apply to combo DVR local end. You need to open web or client end to refresh channel
name.

Time display: You can select to display time or not when system is playing back.

Channel display: You can select to display channel name or not when system is playing back.

Overlay information: System displays some information on the screen for your reference.

Resolution: There are five options: 1400×900(default), 1280×1024, 1280×720, 1024×768, 800×600. Please
note the device needs to reboot to activate setup changes.

Display mode: You can select from the dropdown list.

Enable tour: Activate tour function.

Interval: Input proper interval value here. The value ranges from 5-120 seconds. In tour process, you can use
mouse or click Shift to turn on window switch function.
closing switch function.

Motion tour type: System supports 1/8 window tour.

Alarm tour type: System supports 1/4/9/16 window tour.
Please highlight icon to select the corresponding function.
Figure 5-22
Stands for opening switch function,
59 | P a g e
QC40198 User Manual
stands for