Q-See QC40198 User Manual page 113

WEB OPERATION
PTZ
PTZ interface is shown in Figure 7-48
Please note, before operation make sure you have set speed dome address, and combo DVR and speed dome
connections are OK.
Please refer to the following chart for detailed information.
Parameter Function
Channel
Protocol
Address
Baud
Rate
Data Bit
Stop bit
Parity
Save
Refresh
Figure 7-48
You can select monitor channel from the dropdown list. .
Select the corresponding dome protocol.(such as PELCOD)
Set corresponding dome address. Default value is 1. Your setup here
must comply with your dome address; otherwise you can not control
the speed dome.
Select the dome baud rate. Default setup is 9600.
Default setup is 8. Set according to the speed dome dial switch setup.
Default setup is 1. Set according to the speed dome dial switch setup.
Default setup is none. Set according to the speed dome dial switch
setup.
You can click save button after you complete setup for one channel,
or you can complete the whole setup and then click save button.
Click this button to get device's latest configuration information.
104 | P a g e
QC40198 User Manual