Analog Controller - Frymaster G18FB Series Installation & Operation Manual

SELECTING FRYPOT TEMPERATURE DISPLAY
MODE
To display the actual frypot temperature at all
times, press the Program Mode Switch [ [ [ [ .
Code will appear in the left display. Code
Code Code

ANALOG CONTROLLER

The analog controller uses a frypot-mounted
temperature probe and solid-state electronics
mounted on the control panel. The tempera-
ture probe is connected to the control circuitry
via an interface board behind the control
panel.
The cooking temperature is set by rotating the
Temperature Knob to the desired temperature.
When the Power Switch is placed in the ON
position, electrical current is supplied to the
fryer's components and the Power On Light
illuminates. Placing the Melt Cycle Switch
G18FB & G24FB SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
Power Heat
On Mode
Light Light
Fry m a s t e r
Power Temperature
Switch
ANALOG CONTROLLER
Enter code 1 6 5 L in both number keypads.
The computer will display the actual frypot
temperature. NOTE:
ductcooking process, the cooking time will not
be displayed, but timing is taking place. To
return to setpoint display, repeat the process.
Melt
Trouble Cycle
Light Light
?
SOLID STATE
C
F
Melt Cycle
Knob Switch
in the ON position causes the burners to cycle
on for a few seconds and off for a longer pe-
riod until the temperature in the frypot reaches
180ºF (82ºC). At that time the unit automati-
cally enters the heat mode, causing the burners
to remain lit until the setpoint is reached.
When in the melt cycle, the Melt Cycle Light
will alternately illuminate and go out as the
burners cycle on and off. When the unit enters
the heat mode, the Heat Mode Light
illuminate and remain on until the setpoint is
reached.
3-7
During the pro-
will