Frymaster G18FB Series Installation & Operation Manual page 16

NOTE: A decimal between digits 1 and 2 in
either LED Display indicates that the burners
are on.
1. One of the following will be displayed:
a. cycl cycl cycl, indicating that the fryer is oper- cycl
ating in the melt cycle mode.
fryer will remain in the melt cycle
mode until it reaches 180ºF (82ºC) or
is canceled manually by pressing the R
key.
CAUTION
Do not cancel the melt cycle mode
until solid shortening is completely
melted.
b. hi hi hi hi, indicating that the frypot tempera-
ture is 21ºF (12ºC) higher than the set-
point.
c. LO LO LO LO, indicating that the frypot tempera-
ture is 21ºF (12ºC) lower than the set-
point.
d. "- - - -," indicating that the frypot tem-
perature is in the cooking range.
NOTE: For best results, cooking
should not be attempted unless the dis-
play indicates "- - - -."
e. help help, indicating a heating problem.
help help
f. hot hot, indicating the frypot temperature hot hot
is in excess of 410ºF (210ºC).
g. prob prob, indicating that the computer has
prob prob
detected a problem in the temperature
measuring and control circuits.
h. If the computer has been programmed
by the operator for constant tempera-
G18FB & G24FB SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
The
ture display, the actual frypot tem-
perature will be displayed.
2. Press a product switch to initiate a cook
cycle.
a. The display will indicate the previ-
ously programmed cook time and be-
gin countdown.
b. If shake time is programmed, the op-
erator will be notified of the need to
shake the product "X" seconds after
the cook cycle has begun (X = amount
of time programmed). An alarm will
sound, and the display will read SH#
where "#" will be the switch number.
If no shake time has been programmed,
sh# # # # will not appear during the cook
sh sh sh
cycle. The alarm is self-canceling.
c. At the end of the cooking cycle, an
audible alarm will sound, cooc
displayed, and the associated product
switch indicator will flash. To cancel
the cook alarm, press the appropriate
switch.
d. At this time, the hold time will be dis-
played (if programmed greater than
zero), and the countdown will begin.
When the countdown reaches zero,
hD_ will be displayed and an alarm hD_
hD_ hD_
will sound.
switch number. The hold alarm is can-
celed by pressing the Programming
Switch [ [ [ [ . NOTE: If the display is in
use, the hold time countdown will not
be displayed.
3. To check the frypot temperature at any
time, press the Temperature Check Switch
once. To check the setpoint, press the
switch twice.
3-4
SH#, SH# SH#
cooc will be
cooc cooc
The blank will be the
If you suspect that the