Table of Contents
Advertisement
temperature probe is defective, check the
temperature
of
thermometer or pyrometer to verify that
the computer readout is reasonably close
to the measured reading.
4. During idle periods when the fryer is on
but not in use, "- - - -" should appear in
both displays.
If not, check the actual
temperature and setpoint.
COMPUTER PROGRAMMING INSTRUCTIONS
1. Turn the computer on by pressing the
Power
Switch (or ON/OFF
2. Enter the programming mode by pressing
the Program Mode Switch [ [ [ [ . Code
appear in the left display. If you enter the
programming mode by mistake, press the
switch again to exit the programming
mode. NOTE: If you try to enter the pro-
gramming mode while the computer is
cooking, the display will flash busy
3. Enter the number 1 6 5 0 by pressing the
number keys. Unless this code is entered,
programming will not be accepted. This is
to prevent unauthorized persons from
changing your current instructions.
4. sp-
sp-r (Setpoint) will appear in the left dis-
sp-
sp-
play. Any previously programmed tem-
perature setpoint will appear in the right
display. To change the setpoint, enter the
desired setpoint temperature using the
number keys. The highest setpoint allowed
is 375ºC (191ºC).
Mode Switch [ [ [ [ to lock in the new setpoint
(or the old setpoint, if it was not changed).
5. selp
selp (Select Product) will appear in the
selp
selp
left display. Press the product button to be
G18FB & G24FB SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
the
frypot
with
a
ON
Switch).
OFF
Code will
Code
Code
busy.
busy
busy
Press the Program
programmed (or press
normal operating mode).
6. sens
sens (Sensitivity) appears in the left dis-
sens
sens
play. Any previously programmed sensi-
tivity setting will appear in the right dis-
play.
To change the sensitivity setting,
enter the new setting and press [ [ [ [ to lock it
in. If the setting was not changed, pressing
[ [ [ [ accepts the previous setting.
Sensitivity is a built-in feature that adjusts
cooking time to compensate for the drop in
frypot temperature when a basket of prod-
uct is placed into it. Different food prod-
ucts will vary in density, basket load size,
and initial temperature. Food products
will also vary in how well cooked a prod-
uct is required to be. A proper sensitivity
setting for each product will assure a
high-quality product each time. For ex-
ample: four ounces of fries can be pro-
grammed to be cooked to the same quality
as two and one-half pounds. Some ex-
perimenting with the range of 0 - 9 (0 be-
ing least sensitive and 9 being most sensi-
tive) may be required to obtain the desired
quality to meet your specifications, but
setting 5 is the recommended starting
point.
7. cooc
cooc (Cook Time) will now show in the
cooc
cooc
left display. Any previously programmed
cooking time will appear in the right dis-
play. Pressing [ [ [ [ will accept the current
cooking time.
time, enter the new time using the Number
keys. Press [ [ [ [ to lock in the new time.
8. sh_
sh_ (Shake Time) appears in the left dis-
sh_
sh_
play.
If your product requires shaking
during the cooking process, set the number
of seconds to cook before shaking using
the number keys.
3-5
to return to the
To change the cooking
Advertisement
Table of Contents
Troubleshooting
