Table of Contents
Advertisement
different blower type. Each type is discussed
in following paragraphs.
FPH150 Blower Cleaning Procedure
1. Disconnect the blower wiring harness and
remove the blower assembly mounting
nuts.
Blower
assembly
mounting
nuts
Wiring
connection
2. Remove the three lock nuts that secure the
blower motor assembly to the blower
housing, and separate the two components.
Remove
these nuts
G18FB & G24FB SERIES GAS FRYERS
CHAPTER 5: PREVENTIVE MAINTENANCE
Note:
Silver-colored
Kooltronics
blowers will
have three
screws instead
of three nuts.
Wrap the motor with plastic wrap to
3.
prevent water from entering it.
degreaser or detergent on the blower wheel
and the blower housing. Allow to soak for
five minutes. Rinse the wheel and housing
with hot tap water, then dry with a clean
cloth.
Wrap motor with
plastic wrap
4. Remove the plastic wrap from the blower
motor assembly. Reassemble the blower
motor assembly and blower housing.
Reinstall blower assembly on fryer.
5. Light the fryer in accordance with the
procedure described in Chapter 3, Section
3.1.
6. After the burners have been lit for at least
90 seconds, observe the flames through the
burner viewing ports located on each side
of the combustion air blower.
5-4
Spray
Blower Wheel
Left
Viewing
Right
Viewing
Port
Port
Behind
Motor
Advertisement
Table of Contents
Troubleshooting
