Setting Up And Following The Zigzag Pattern; Following The Williamson Turn Pattern; Cancelling A Steering Pattern; Controlling The Virb ® Action Camera With The Aquamap - Garmin AQUAMAP 10x2 Series Owner's Manual

Setting Up and Following the Zigzag Pattern

You can use the zigzag pattern to steer the boat from port to starboard and
back, over a specified time and angle, across your present heading.
1 From the autopilot screen, select MENU > Pattern Steering > Zigzag.
2 If necessary, select Amplitude, and select a degree.
3 If necessary, select Period, and select a length of time.
4 Select Engage Zigzag.

Following the Williamson Turn Pattern

You can use the Williamson turn pattern to steer the boat around with the
intent of running alongside the location where the Williamson turn pattern
was initiated. The Williamson turn pattern can be used in man-overboard
situations.
1 From the autopilot screen, select MENU > Pattern Steering > Williamson
Turn.
2 Select Engage Port or Engage Starboard.

Cancelling a Steering Pattern

• Physically steer the boat.
NOTE: Shadow Drive must be enabled to cancel a steering pattern by
physically steering the boat.
• Select or to cancel a pattern using step steering mode.
• Select Standby.
Controlling the VIRB Action Camera with the
®
AQUAMAP
Before you can control a VIRB action camera with the AQUAMAP, you must
connect the devices using a wireless connection.
You can connect up to five VIRB action cameras to the AQUAMAP.
AQUAMAP™ 10x2/12x2 SERIES
After you connect the VIRB action camera with the AQUAMAP, a new option
is added to A/V, Gauges, Controls. You can start and stop recording on the
VIRB action camera using the AQUAMAP.
NOTE: The VIRB image shown on the AQUAMAP is a in a lower resolution
than the VIRB action camera records. To view the high-resolution video, view
the video on a computer or television.
1 Select A/V, Gauges, Controls > VIRB
2 Select an option:
• To take a still photograph, select
• To begin recording, select
memory is shown.
• To stop recording, select
• If you have more than one VIRB action camera connected, use the
arrows to select a different action camera to control.
• To view stored videos or images, select

VIRB Action Camera Settings

Select A/V, Gauges, Controls > VIRB
Name: Allows you to enter a new name for the VIRB action camera.
Recording: Starts and stops recording.
Take Photo: Takes a still photograph.
Sleep: Puts the VIRB action camera into a low power mode to conserve
battery power.

VIRB Action Camera Video Setup Settings

Select A/V, Gauges, Controls > VIRB
Aspect: Sets the video aspect ratio.
Video Mode: Sets the video mode. For example, you can select the Slow-Mo
option to shoot slow motion videos.
.
®
.
. When recording, the remaining recording
again.
.
> MENU.
®
> MENU > Video Setup.
®
83