Configuring The Sailing Wind Gauge; Configuring The Speed Source; Configuring The Heading Source Of The Wind Gauge; Customizing The Close-Hauled Wind Gauge - Garmin AQUAMAP 10x2 Series Owner's Manual

Configuring the Sailing Wind Gauge

You can configure the sailing wind gauge to show true or apparent wind
speed and angle.
1 From the wind gauge, select MENU > Sailing Wind Gauge.
2 Select an option:
• To show true or apparent wind angle, select Needle, and select an
option.
• To show true or apparent wind speed, select Wind Speed, and select
an option.

Configuring the Speed Source

You can specify whether the vessel speed data displayed on the gauge and
used for wind calculations is based on water speed or GPS speed.
1 From the wind gauge, select MENU > Compass Gauge > Speed Display.
2 Select an option:
• To calculate the vessel speed based on data from the water-speed
sensor, select Water Speed.
• To calculate the vessel speed based on GPS data, select GPS Speed.

Configuring the Heading Source of the Wind Gauge

You can specify the source of the heading displayed on the wind gauge.
Magnetic heading is the heading data received from a heading sensor, and
GPS heading is calculated by your AQUAMAP GPS (course over ground).
1 From the wind gauge, select MENU > Compass Gauge > Heading
Source.
2 Select GPS Hdg. or Magnetic.
NOTE: When moving at low speeds or when stationary, the magnetic
compass source is more accurate than the GPS source.
72

Customizing the Close-Hauled Wind Gauge

You can specify the range of the close-hauled wind gauge for both the upwind
scale and the downwind scale.
1 From the wind gauge, select MENU > Compass Gauge > Gauge Type >
Close Hauled Gauge.
2 Select an option:
• To set the maximum and minimum values that appear when the upwind
close-hauled wind gauge appears, select Change Upwind Scale, and
set the angles.
• To set the maximum and minimum values that appear when the
downwind close-hauled wind gauge appears, select Change
Downwind Scale, and set the angles.
• To view true or apparent wind, select Wind, and select an option.

Viewing Trip Gauges

Trip gauges show information for odometer, speed, time, and fuel for your
present trip.
Select NAV INFO > Trip & Graphs > Trip.

Resetting Trip Gauges

1 Select NAV INFO > Trip & Graphs > Trip.
2 Select an option:
• To set all the readings for the present trip to zero, select Reset Trip.
• To set the maximum speed reading to zero, select Reset Maximum
Speed.
• To set the odometer reading to zero, select Reset Odometer.
• To set all the readings to zero, select Reset All.
AQUAMAP™ 10x2/12x2 SERIES