Customizing Engine Gauge And Fuel Gauge Limits; Viewing Engine And Fuel Gauges; Selecting The Number Of Engines Shown In Gauges; Customizing The Engines Shown In Gauges - Garmin AQUAMAP 10x2 Series Owner's Manual

1 From an applicable gauges screen, select MENU > Edit Gauge Pages.
2 Select an option:
• To change the data shown in a gauge, select the gauge.
• To change the layout of the gauges on the page, select Change
Layout.
• To add a page to this set of gauge pages, select Add Page.
• To remove a page from this set of gauge pages, select Remove Page.
• To change the order of this page in the set of gauge pages, select
Move Page Left or Move Page Right.
• To restore this page to the original view, select Restore Default View.

Customizing Engine Gauge and Fuel Gauge Limits

You can configure the upper and lower limits and the range of desired
standard operation of a gauge.
NOTE: Not all options are available for all gauges.
1 From an applicable gauges screen, select MENU > Set Gauge Limits.
2 Select a gauge to customize.
3 Select an option:
• To set the minimum value of the standard operating range, select
Rated Min..
• To set the maximum value of the standard operating range, select
Rated Max..
• To set the lower limit of the gauge lower than the rated minimum, select
Scale Min..
• To set the upper limit of the gauge higher than the rated maximum,
select Scale Max..
4 Select the limit value.
5 Repeat steps 2 to 4 to set additional gauge limits.
70

Viewing Engine and Fuel Gauges

Before you can view engine and fuel gauges, you must be connected to
a NMEA 2000 network capable of sensing engine and fuel data. See the
installation instructions for details.
Select A/V, Gauges, Controls > Engines.

Selecting the Number of Engines Shown in Gauges

You can show information for up to four engines.
1 From the engine gauges screen, select MENU > Installation > Engine
Selection > Num. Engines.
2 Select an option:
• Select the number of engines.
• Select Auto Configure to automatically detect the number of engines.

Customizing the Engines Shown in Gauges

Before you can customize how the engines are shown in the gauges, you
must manually select the number of engines.
1 From the engine gauges screen, select MENU > Installation > Engine
Selection > Edit Engines.
AQUAMAP™ 10x2/12x2 SERIES