6-44
6. After installing the connector-unit board kit [29], assemble the radio by following the steps
outlined in
6.2.3.6 Option Board Disassembly/Reassembly
NOTE:The two types of option boards available are: the PM1200 Quik Call II Decoder Option Board
(HKLN4346_) and the PM1200 Digital ANI Encoder Option Board (HKLN4347_). These
option boards need to be installed together with an Interface Board (HKLN4345_).
NOTE:Bracketed numbers are identical to item numbers shown in
Exploded View" on page
6.2.3.6.1 Option Board Disassembly
1. Ensure all the accessory connections, power, antenna, and microphone are unplugged.
2. Using a CR-V PH2 screwdriver, remove the 7 binding head screws, M3x6 SUS B from the top
cover as shown in
3. Using a CR-V PH1 screwdriver, remove a taptite screw M2.6x6 from the chassis as shown in
Figure
6-84.
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
6.2.3.4.2: "PA-Unit Board Kit Reassembly" on page
9-3.
Figure
6-82.
5
2
1
Figure 6-83. Removing Screws from Top Cover
Figure 6-84. Removing Screws from Chassis
4
3
6
7
6-34.
Figure 9-2. "PM1200 Radio
6880309U09-A