Figure 6-68. Sequence For Installing Binding Head Screws On Pa-Unit Board Kit; Figure 6-69. Resoldering Antenna Connector And Earth Plate - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
8. Using a CR-V PH2 torque driver, fasten the 2 binding head screws, M3x6 SUS [6] to the
assemble earth plate [33] and the antenna connector [32] to the chassis [11] as shown in
Figure 6-68. (Torqued to 3.5–4.6 kgf*cm/ 3–4 in. lbs)

Figure 6-68. Sequence for Installing Binding Head Screws on PA-Unit Board Kit

9. Carefully resolder the antenna connector [32] and the earth plate [33] to the PCB as shown in
Figure 6-69.

Figure 6-69. Resoldering Antenna Connector and Earth Plate.

6880309U09-A
1
2
Earth Plate
Antenna Connector
6-37
October 26, 2007