Rf-Interface Board Kit Reassembly; Main-Unit Board Kit Disassembly/Reassembly; Main-Unit Board Kit Disassembly; Figure 6-35. Sequence For Installing Rf-Interface Kit Screws - Motorola PM1200 Basic Service Manual

6-20

6.2.3.2.2 RF-Interface Board Kit Reassembly

1. Seat the RF-Interface unit board kit [7] in the front panel [4] to the screw bosses. Ensure that
the aligning boss protrudes through the PCB.
2. Using a CR-V PH1 torque driver, fasten the 4 taptite head screws, M2.6x6 [8] following the
sequence as shown in
3. After installing the RF-Interface board kit, reassemble the front panel by following the steps
outlined in

6.2.3.3 Main-Unit Board Kit Disassembly/Reassembly

NOTE:Bracketed numbers are identical to item numbers shown in
Exploded View" on page

6.2.3.3.1 Main-Unit Board Kit Disassembly

IMPORTANT:
1. Ensure all accessory connections, power, antenna, and microphone are unplugged.
2. Disassemble the front panel by following the steps outlined in
Panel Disassembly" on page
October 26, 2007
Figure 6-34.(Torqued to 3.5–4.6 kgf*cm/ 3–4 in. lbs).
4

Figure 6-35. Sequence for Installing RF-Interface Kit Screws

6.2.3.1.2: "Transceiver Front Panel Reassembly" on page 6-16.
9-3.
See "Option Board Disassembly/Reassembly" on page 6-44
disassembly the main Unit
6-14.
Disassembly/Reassembly Procedures: Replacement Procedures
1
3
2
Figure 9-2. "PM1200 Radio
before
6.2.3.1.1: "Transceiver Front
6880309U09-A