Pa-Unit Board Kit Disassembly/Reassembly; Pa-Unit Board Kit Disassembly; Figure 6-50. Connecting Power Wire Assembly To Main-Unit Board Kit; Figure 6-51. Removing Screws From Top Cover - Motorola PM1200 Basic Service Manual

6-28
10. Place the power wire assembly [37] to the terminal by using a CR-V PH2 torque driver, fasten
the 2 SEMS screws, HSM3x6 NI [17] to the main-unit board kit [13] as shown in
(Torqued to 5.8–6.9 kgf*cm/ 5–6 in. lbs)

Figure 6-50. Connecting Power Wire Assembly to Main-Unit Board Kit

11. After installing the main-unit board kit, reassemble the front panel by following the steps
outlined in

6.2.3.4 PA-Unit Board Kit Disassembly/Reassembly

NOTE:Bracketed numbers are identical to item numbers shown in
Exploded View" on page

6.2.3.4.1 PA-Unit Board Kit Disassembly

1. Ensure all accessory connections, power, antenna, and microphone are unplugged.
2. Using a CR-V PH2 screwdriver, remove the 7 binding head screws, M3x6 SUS B [23] from
the top cover [24] as shown in
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
1
2
6.2.3.1.2: "Transceiver Front Panel Reassembly" on page 6-16.
9-3.
Figure
5
2
1

Figure 6-51. Removing Screws from Top Cover

6-51. Save them for later use.
4
3
6
7
Figure
Figure 9-2. "PM1200 Radio
6880309U09-A
6-50.