Disassembly & Reassembly And Replacement Procedures; General; Disassembly To Transceiver Board Level Low And Mid Power Models; Remove The Control Head - Motorola MCS 2000 Service Instructions Manual

Disassembly & Reassembly
and Replacement Procedures

General

!
C a u t i o n
Disassembly to Transceiver Board Level
Low and Mid Power Models
Remove the
Control Head
The disassembly/reassembly procedure covers all radio models. Specific model
information is included in the procedure where relevant. Where nothing is
indicated, the procedure will be valid for all models.
DO NOT attempt to disassemble the radio without first referring to the
CMOS Precautions paragraph on page 2-2 in the Maintenance section.
Steps 1 and 2, Removal of the Retention Frame, are only
Note
valid for Models II and III, Low and Mid Power Dash Mount
version radios.
1. On Models II & III, Dash Mount only : Prior to removing the control
head, remove the retention frame by inserting a small flat blade
screwdriver in the cut outs provided.
2. On Models II & III, Dash Mount only : Slide the retention frame away
from the control head groove.
3. Insert a small blade screw driver or like instrument in the side groove at the
interface between the control head and the transceiver (see Figure 5-1). While
pulling the control head away from the transceiver press until the control
head side releases, and then repeat the operation on the opposite side.
See Detail "A"
Detail "A"
Figure 5-1 Removing the Control Head
Disassembly & Reassembly and Replacement Procedures
5
Control Head I
Transceiver
Depress Snap Here
5-1