Main-Unit Board Kit Reassembly; Figure 6-42. Removing The Main-Unit Board Kit; Figure 6-43. Pasting Poron Pad To Main-Unit Board Kit - Motorola PM1200 Basic Service Manual

6-24
10. Separate the main-unit board kit [13] by holding the metal cover as shown in
lifting up the back of the PCB.
11. Slide the main board towards the back of the chassis [11] and carefully lift it out of the
chassis. Hold the main-unit board kit [13] by the edges only, and store it in an antistatic bag.

6.2.3.3.2 Main-Unit Board Kit Reassembly

To assemble your radio:
1. Prior to reassembly the radio, inspect the poron pads [12], [18] and poron pad (VCO) [19] for
damage or dirt. Refer to
numbers, and replace parts, as necessary.
2. Take out the main-unit board kit [13] from the antistatic bag by holding the edges of the board.
3. Paste the new poron pad [18] to the main unit board kit [13] as shown in
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures

Figure 6-42. Removing the Main-Unit Board Kit

Chapter 9. Exploded Views and Parts Lists

Figure 6-43. Pasting Poron Pad to Main-Unit Board Kit

for the correct part
Figure
Poron Pad (VCO)
Figure 6-42 and
6-43.
6880309U09-A