Disassembly/Reassembly Procedures: Replacement Procedures
3. Using a CR-V PH2 screwdriver, remove the 2 SEMS screws, HSM3x6 NI [17] from the
main-unit board kit [13] as shown in
4. Carefully separate the two power wire assembly wires [37] from the original location.
5. Unplug the mating connector [A] on the wire assembly 160mm 20P26P [26] from the
main-unit board kit [13] as shown in
6880309U09-A
Figure 6-36. Removing Screws from Main-Unit Board Kit
Mating Connector [A]
Figure 6-37. Removing Screws from Main-Unit Board Kit
Figure
6-36.
1
2
Figure
6-37.
6-21
October 26, 2007