Application And Setting Notes; Settings - Siemens SIPROTEC 5 Manual

Fault Recorder
7.6 Measurands and Recorder Routing Functions
Table 7-17
Measurand
SPS messages
7.6.2.4

Application and Setting Notes

Settings of the Recorder Routing V Function
[Screcrou-030614-01, 1, en_US]
Figure 7-72
This representation applies in a similar manner to the Recorder routing VI function.
The Recorder routing V function can only be added to the Voltage 3-phase function group.
The procedure is described in chapter
the DIGSI Help.
Parameter: Tol. trend frequency
•
Default setting (_:15271:101) Tol. trend frequency = 0.200 %
Using the parameter Tol. trend frequency, you set the tolerance range for the frequency measured
value at which a new RMS value is recorded following an exceedance.
The setting value refers to the rated frequency set as a parameter.
Parameter: Tol. trend voltage
•
Default setting (_:15271:102) Tol. trend voltage = 2.000 %
Using the parameter Tol. trend voltage, you set the tolerance range for the voltage measured value at
which a new RMS value is recorded following an exceedance.
The setting value refers to the rated voltage set as a parameter.

Settings

7.6.2.5
Addr.
General
_:15271:101
354
Using SPS Indications
Refresh Rate
Event-based
Settings of the Recorder Routing V
7.1.2 Step 1: Creating a New Project and Adding a New Device
Parameter
General:Tol. trend
frequency
FSR
X
C Setting Options
0.010 % to 1.000 %
Use in
SSR CR
X
Default Setting
0.200 %
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
TR
X
and in