Table of Contents
Advertisement
X-Axis Power Feed
X
Y
AA
AB
Figure 7. X-Axis power feed components.
X. X-Axis Limit Switch: Stops powered table
movement when either side plunger comes
in contact with limit stops.
Y. X-Axis Limit Stops: Limit X-axis table travel
(one on each end of table).
Z.
Graduated Dial: Displays X-axis table move-
ment in 0.001" increments, with each revolu-
tion equaling 0.200" of travel.
AA. Directional Lever: Selects direction of table
movement. Center position is neutral.
AB. Speed Dial: Controls speed of table X-axis
movement. Turning dial clockwise causes
table to move faster.
Note: A lot of variables are involved when
determining proper feed rates. We recom-
mend that you combine research and experi-
mentation to find feed rates that best work for
your specific operations.
AC. Reset Button: Resets internal circuit breaker
if power feed is overloaded and shuts down.
AD. ON/OFF Switch: Enables/disables power to
power feed.
AE. Rapid-Traverse Button: Once directional
lever has been activated, causes table to
travel at full speed but only while pushed.
IMPORTANT: Avoid contact with handwheel
while
rapid-traverse
handwheel will rotate at a rapid rate.
Model G0827 (Mfd. Since 11/17)
Z
AE
AC
AD
is
pressed;
table
Y-Axis Power Feed
AF
AL
AM
Figure 8. Y-Axis power feed components.
AF. Y-Axis Limit Switch: Stops powered table
movement when it comes in contact with limit
stops.
AG. Directional Lever: Selects direction of table
movement. Center position is neutral.
AH. Graduated Dial: Displays Y-axis table move-
ment in 0.001" increments, with each revolu-
tion equaling 0.200" of travel.
AI. Rapid-Traverse Button: Once directional
lever has been activated, causes table to
travel at full speed but only while pushed.
IMPORTANT: Avoid contact with handwheel
while
rapid-traverse
handwheel will rotate at a rapid rate.
AJ. ON/OFF Switch: Enables/disables power to
power feed unit.
AK. Reset Button: Resets internal circuit breaker
if power feed is overloaded and shuts down.
AL. Speed Dial: Controls speed of table Y-axis
movement. Turning dial clockwise causes
table to move faster.
Note: A lot of variables are involved when
determining proper feed rates. We recom-
mend that you combine research and experi-
mentation to find feed rates that best work for
your specific operations.
AM. Y-Axis Limit Stops: Limits Y-axis table
travel (one on either end of table).
AG
AH
AI
AJ
AK
is
pressed;
table
-7-
Advertisement
Table of Contents
