Spindle Speed - Grizzly G0827 Owner's Manual

Spindle Speed

Using the correct spindle speed is important for
safe and satisfactory results, as well as maximiz-
ing tool life.
To set the spindle speed for your operation, you
will need to: (1) Determine the best spindle speed
for the cutting task, and (2) configure the mill con-
trols to match the closest spindle speed.
Determining Spindle Speed
Many variables affect the optimum spindle speed
to use for any given operation, but the two most
important are the recommended cutting speed for
the workpiece material and the diameter of the
cutting tool, as noted in Figure 43:
*
Recommended
Cutting Speed (FPM) x 12
Tool Diameter (in inches) x 3.14
*
Double if using carbide cutting tool
Figure 43. Spindle speed formula for milling.
Cutting speed, typically defined in feet per minute
(FPM), is the speed at which the edge of a tool
moves across the material surface.
A recommended cutting speed is an ideal speed
for cutting a type of material in order to produce
the desired finish and optimize tool life.
The books Machinery's Handbook or Machine
Shop Practice, and some internet sites, pro-
vide excellent recommendations for which cutting
speeds to use when calculating the spindle speed.
These sources also provide a wealth of additional
information about the variables that affect cutting
speed and are a good educational resource.
Also, there are a large number of easy-to-use
spindle speed calculators that can be found on
the internet. These sources will help you take into
account all applicable variables to determine the
best spindle speed for the operation.
-36-
Cutting Speeds for High Speed Steel (HSS)
Workpiece Material
Aluminum & Aluminum Alloys
Brass & Bronze
Copper
Cast Iron, soft
Cast Iron, hard
Mild Steel
Cast Steel
Alloy Steel, hard
Tool Steel
Stainless Steel
Titanium
Plastics
Wood
Note: For carbide cutting tools, double the cut-
ting speed. These values are a guideline only.
Refer to the MACHINERY'S HANDBOOK for
more detailed information.
=
RPM
To avoid damaging spindle, gears, or cutting
tools when setting spindle speed range:
• Spindle rotation must be turned OFF and
spindle must be at complete stop BEFORE
you change spindle speed range.
• To avoid damaging moving parts inside
headstock, never start spindle rotation
without speed selector detent pins firmly
seated in correct position.
Cutting Tools
Cutting Speed (sfm)
Figure 44. Cutting speed table.
Model G0827 (Mfd. Since 11/17)
300
150
100
80
50
90
80
40
50
60
50
300-800
300-500