Table of Contents
Advertisement
Mill Test Run
1.
Clear all setup tools away from machine.
2.
Set vertical spindle to 140 RPM (see Page 36
for details on how to change speeds).
3.
Push E-STOP button (see Figure 22) to
avoid unexpected start up when machine is
connected to power.
Figure 22. Location of E-STOP button.
4.
Connect mill to power supply specified in
POWER SUPPLY on Page 14.
5.
Turn master power switch ON (see Figure 23).
Figure 23. Location of master power switch.
6.
Twist E-STOP button clockwise until it pops
out—this resets it and allows mill to operate.
Model G0827 (Mfd. Since 11/17)
E-STOP Button
Master
Power
Switch
7.
Press POWER button (see Figure 24) on
control panel to enable power to machine—
power button should illuminate.
8.
Press FORWARD button (see Figure 24) for
(vertical spindle).
FORWARD
Button
(Vertical
Spindle)
POWER
Button
Figure 24. Location of vertical spindle
FORWARD button and POWER button.
9.
Listen for abnormal noises and watch for
anything unexpected from mill. It should run
smoothly and without excessive vibration or
rubbing noises.
— Strange or unusual noises or actions
must be investigated immediately. Turn
machine OFF and disconnect it from the
power source before investigating or cor-
recting potential problems.
-25-
Advertisement
Table of Contents
