Grizzly G0827 Owner's Manual page 36

Installing Horizontal
Tooling
Single or multiple cutters (gang milling) can be
arranged anywhere along the length of the arbor
for simple to very complex cutting operations.
The Model G0827 includes the following horizon-
tal spindle tools (see Figure 39):
A. 1 ⁄ " Dia. Horizontal Arbor w/Spacers. Used
1
4
for horizontal milling operations with 1
cutters.
B. 1" Dia. Horizontal Arbor w/Spacers. Used
for horizontal milling operations with 1" bore
cutters.
A
B
Figure 39. Horizontal arbors included with
G0827.
Tools Needed
Open-End Wrench 19mm .................................. 1
Open-End Wrenches 24mm .............................. 2
Open-End Wrench 32mm .................................. 1
Brass Hammer .................................................. 1
-34-
Spindle &
⁄ " bore
1
4
Qty
To install horizontal tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen locking bolt on side of arbor sup-
port, and slide support off ram dovetail way
(see Figure 40).
Ram Rotation
Locking Bolt
Hex Nuts (2 of 4)
Horizontal
Arbor Support
Figure 40. Horizontal arbor support, locking bolt,
and ram rotation hex nut locations.
3. Loosen ram rotation hex nuts (see Figure
40), then rotate ram 180°, as shown in
Figure 41.
Note: Make sure "0" marks on ram base and
angle scale are aligned and four ram rotation
hex nuts are retightened.
Arbor
Figure 41. Horizontal arbor seated in spindle
with ram fully extended and rotated 180 degrees.
Model G0827 (Mfd. Since 11/17)
Horizontal
Spindle