Grizzly G0827 Owner's Manual page 8

Headstock
P
O
Figure 3. Location of headstock controls.
L. Spindle Speed Selectors: Selects one of
four spindle speeds in selected speed range.
M. Coarse Downfeed
moves quill downward when pulled down.
Automatically retracts spindle to top posi-
tion when released. Typically used for drilling
operations.
N. Downfeed Selection Lever: When tight-
ened, enables fine downfeed handwheel;
when loosened, enables coarse downfeed
levers.
O. Fine Downfeed Handwheel: Manually con-
trols vertical spindle downfeed for fine Z-axis
control.
P. Quill Lock: Locks quill in vertical position.
Column
Q
Figure 4. Location of horizontal spindle speed
selector knobs.
Q. Horizontal Spindle Speed Selector Knobs:
Configures gearing inside column to produce
various horizontal spindle speeds.
-6-
M
L
N
Levers: Quickly
Table
R
Figure 5. Table controls and components.
V
Figure 6. Location of Y- and Z-axis locks.
R. X-Axis Handwheel (1 of 2): Manually moves
table along X-axis (left and right).
S. X-Axis Table Locks: When tightened, pre-
vents X-axis table movement for increased
rigidity during operations where the X-axis
should not move.
T. Y-Axis Handwheel: Manually moves table
along Y-axis (front and back).
U. Knee Crank: Manually moves table along
Z-axis (up and down).
V. Y-Axis Table Locks: When tightened, pre-
vents Y-axis table movement for increased
rigidity during operations where the Y-axis
should not move.
W. Z-Axis Column Lock: When tightened, pre-
vents Z-axis table movement for increased
rigidity during operations where the Z-axis
should not move.
Model G0827 (Mfd. Since 11/17)
S
T
U
W