Position Spindle - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Working in manual mode
5.3 Traversing axes
Note
Changing the spindle speed
If you enter the speed in the "Spindle" field while the spindle is rotating, the new speed is
applied.
5.2.4
Position spindle
Procedure
Note
You can use this function to position the spindle at a specific angle, e.g. during a tool change.
● A stationary spindle is positioned via the shortest possible route.
● A rotating spindle is positioned as it continues to turn in the same direction.
5.3
Traversing axes
You can traverse the axes in manual mode via the Increment or Axis keys or handwheels.
92
1.
Select the "JOG" operating mode.
2.
Press the "T, S, M" softkey.
3.
Select the "Stop Pos." setting in the "Spindle M function" field.
The "Stop Pos." entry field appears.
4.
Enter the desired spindle stop position.
The spindle position is specified in degrees.
5.
Press the <CYCLE START> key.
The spindle is moved to the desired position.
Operating Manual, 05/2017, A5E40868517
Universal
Advertisement
Table of Contents
