Blank Input - Siemens SINUMERIK 840D sl Operating Manual

Creating a G code program

8.6 Blank input

Part programs in the G code can be created under the "Workpiece" folder or under the "Part
programs" folder.
Procedure
Creating a new part program
Creating a new part program for a workpiece
8.6 Blank input
8.6.1 Overview
Function
The blank is used for the simulation and the simultaneous recording. A useful simulation can
only be achieved with a blank that is as close as possible to the real blank.
Create a separate program for each new workpiece that you would like to produce. The
program contains the individual machining steps that are performed to produce the workpiece.
196
1. Select the "Program Manager" operating area.
2. Select the required archiving location.
3. Position the cursor on the folder "Part programs" and press the "New"
softkey.
The "New G Code Program" window opens.
4. Enter the required name and press the "OK" softkey.
The name can contain up to 28 characters (name + dot + 3-character
extension). You can use any letters (except accented), digits or the un‐
derscore symbol (_).
The program type (MPF) is set by default.
The project is created and opened in the Editor.
5. Position the cursor on the folder "Workpieces" and press the "New" soft‐
key.
The "New G Code Program" window opens.
6. Select the file type (MPF or SPF), enter the desired name of the program
and press the "OK" softkey.
The project is created and opened in the Editor.
7. Enter the desired G code commands.
Operating Manual, 05/2017, A5E40868517
Universal