Siemens SINUMERIK 840D sl Operating Manual page 125

Display
Addit. run-in code
Automat. Retraction
Procedure
Opening and closing blocks
Remove block
Universal
Operating Manual, 05/2017, A5E40868517
Meaning
● Yes
For the case that the block is not executed, as the specified spindle should
not be processed, then it is possible to temporarily activate a so-called
"Addit. run-in code".
● No
● Yes
Block start and block end are moved to the tool change point, i.e. the tool
is brought into a safe range.
● No
1. Select the "Program Manager" operating area.
2. Select the storage location and create a program or open a program.
The program editor opens.
3. Select the required program blocks that you wish to combine to form a
block.
4. Press the "Build block" softkey.
The "Build Block" window opens.
5. Enter a designation for the block, assign the spindle, if required, select
the additional run-in code and the automatic retraction and then press
the "OK" softkey.
6. Press the ">>" and "View" softkeys.
7. Press the "Open blocks" softkey if you wish to display the program with
all blocks.
8. Press the "Close blocks" softkey if you wish to display the program again
in a structured form.
9. Open the block.
10. Position the cursor at the end of the block.
11. Press the "Remove block" softkey.
Machining the workpiece
6.10 Editing a program
125