Siemens SINUMERIK 840D sl Operating Manual page 228
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Tool management
11.5 Tool list
Procedure
Loading empty magazine location directly with tool
Several magazines
If you have configured several magazines, the "Load to ..." window appears after pressing the
"Load" softkey.
If you do not want to use the suggested empty location, then enter your desired magazine and
magazine location. Confirm your selection with "OK".
Multiple load points
If you have configured several loading points for a magazine, then the "Loading Point
Selection" window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
Unloading tools
228
1.
The tool list is opened.
2.
Place the cursor on the tool that you want to load into the magazine (if
the tools are sorted according to magazine location number you will find
it at the end of the tool list).
3.
Press the "Load" softkey.
The "Load to... " window opens.
The "... location" field is initialized with the number of the first empty mag‐
azine location.
4.
Press the "OK" softkey to load the tool into the suggested location.
- OR -
Enter the location number you require and press the "OK" softkey.
- OR -
Press the "Spindle" softkey.
The tool is loaded into the specified magazine location or spindle.
1.
Position the cursor at an empty magazine location where you want to
load a tool and press the "Load" softkey.
The "Load with ..." window opens.
Select the desired tool in the " ... Tool" field and press the "OK" softkey.
1.
Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" softkey.
2.
Select the required load point in the "Loading Point Selection" window.
Operating Manual, 05/2017, A5E40868517
Universal
Advertisement
Table of Contents
