Logging An Active User On And Off - Siemens SINUMERIK 840D sl Operating Manual

● Machine faults
An SMS is sent if PLC alarms or messages are output that cause the machine to come to
a standstill (i.e. PLC alarms with an Emergency Stop response).
● Maintenance intervals
An SMS is sent if the service planner registers pending maintenance work.
● Additional alarm numbers:
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
Requirement
● The "User profiles" window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle messages
for workpieces", "Sinumerik messages/alarms (errors when executing)", "Machine faults"
or "Maintenance intervals".
Editing events
17.5

Logging an active user on and off

Only active users receive an SMS message for the specified events.
You can activate users, already created for Easy Message, with certain control commands via
the user interface or via SMS.
Universal
Operating Manual, 05/2017, A5E40868517
1. Activate the required check box and press the "Details" softkey.
The appropriate window opens (e.g. "Measuring cycle messages for
workpieces") and shows a list of the defined alarm numbers.
2. Select the corresponding entry and press the "Delete" softkey to remove
the alarm number from the list.
- OR -
Then press the "New" softkey if you wish to create a new entry.
The "Create new entry" window opens.
Enter the data and press the "OK" softkey to add the entry to the list.
Press the "Save" softkey to save the settings for the result.
3. Press the "Standard" softkey to return to the standard settings for the
events.
Easy Message (828D only)
17.5 Logging an active user on and off
351