● SC sum correction
● Total length
● Radius / radius wear
Procedure
...
Universal
Operating Manual, 05/2017, A5E40868517
You can also change the display of the tool correction values between the Ma‐
chine Coordinate System and the Workpiece Coordinate System.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1.
Select the "Parameter" operating area.
2.
Press the "Zero offset" softkey.
3.
Press the "Active", "Base" or "G54...G599" softkey.
The corresponding window opens.
4.
Place the cursor on the desired zero offset to view its details.
5.
Press the "Details" softkey.
A window opens, depending on the selected zero offset, e.g. "Zero Offset
- Details: G54 to G599".
6.
You can edit the values directly in the table.
- OR -
Press the "Clear offset" softkey to reset all entered values.
Press the "ZO +" or "ZO -" softkey to select the next or previous offset,
respectively, within the selected area ("Active", "Base", "G54 to G599")
without first having to switch to the overview window.
If you have reached the end of the range (e.g. G599), you will switch
automatically to the beginning of the range (e.g. G54).
Setting up the machine
4.5 Zero offsets
79