Siemens SINUMERIK 840D sl Operating Manual page 302

Managing programs
12.17 Setup data
● Zero points
● Basic zero point
Tool data
Depending on which data you have selected, the system behaves as follows:
● Complete tool list
First, all tool management data are deleted and then the saved data are imported.
● All tool data used in the program
If at least one of the tools to be read in already exists in the tool management system, you
can choose between the following options.
Selecting loading point
For a magazine, if more than one loading point was set-up, using the "Select loading point"
softkey, you have the option of opening a window in which you can assign a loading point to
a magazine.
Procedure
302
Select the "Replace all" softkey to import all tool data. Any existing tools
will now be overwritten without a warning prompt.
- OR -
Press the "Do not overwrite" softkey if existing tools must not be over‐
written.
Already existing tools are skipped, without you receiving any queries.
- OR -
Press the "Skip" softkey if already existing tools are not to be overwritten.
For an already existing tool, you receive a query.
1. Select the "Program Manager" operating area.
2. Position the cursor on the file with the backed-up tool and zero point data
(*.INI) that you wish to re-import.
3. Press the <Cursor right> key
- OR -
Double-click the file.
The "Read-in setup data" window opens.
Operating Manual, 05/2017, A5E40868517
Universal