Replacing The Batteries - Fluke 724 Calibration Manual

Replacing the Batteries

To avoid electric shock, remove the test leads from the Calibrator
before opening the battery door. Close and latch the battery door
before using the Calibrator.
To avoid false readings, which can lead to possible electric shock or
personal injury, replace the batteries as soon as the low battery

indicator ( ) appears.
When replacing the batteries, always use four new AA batteries. Never
mix new and used batteries in the Calibrator.
Fuses are only in 724 and 725 Version 2.X and lower.
Four AA alkaline batteries (ANSI/NEDA 15A or IEC LR6) are used to power the
Calibrator. To replace the batteries, refer to Figure 1 and do the following:
1. Turn the Calibrator off, remove the test leads from the terminals, and hold the
Calibrator face down.
2. Using a flat-blade screwdriver, turn the battery door screws 1/4-turn
counterclockwise and remove the battery door.
3. Remove the batteries, then install new batteries. Be sure to follow the polarity
markings shown in the battery compartment.
4. Replace the battery door and secure it by turning the screws 1/4-turn clockwise.
Figure 1. Replacing the Batteries and Replaceable Fuses

Warning
Note
Calibrators
Replacing the Batteries
aal01f.eps
13