Table of Contents
Advertisement
14.5 Configuring the Modem
The modem must be programmed with the Call Out telephone numbers in order to
operate the Remote Notification option.
To configure the modem, connect the serial port of a standard PC computer to
the modem through the serial cable. Run a terminal emulation program on the
computer. Test the connection to the modem by typing [A], [T] and [ENTER].
The modem should respond with either "OK" or "0" (zero). If the modem does not
respond, consult the modem manufacturer's manual to confirm your setup. If the
modem still does not respond, then seek technical assistance from your modem
manufacturer.
After connection, perform "Basic Modem Configuration" and the remaining
sections of this chapter.
14.5.1
Basic Modem Configuration
The basic modem should be a plug and play type. All setup is done by the UPS.
Only the initial phone number needs to be entered by the user.
Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM
164201373 Rev. A
092402
14--5
Advertisement
Table of Contents
