Configuration Tasks; Show Lldp - Enterasys SecureStack C2 Configuration Manual

Configuration Tasks

The commands included in this implementation allow you to perform the following configuration
tasks:
Step
1.
2.

show lldp

Use this command to display LLDP configuration information.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP configuration information.
C2(ro)->show lldp
Message Tx Interval
Message Tx Hold Multiplier : 4
Notification Tx Interval
MED Fast Start Count
Tx-Enabled Ports
Rx-Enabled Ports
Trap-Enabled Ports
MED Trap-Enabled Ports
Task
Configure global system LLDP parameters
Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
Command(s)
set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
: 30
: 5
: 3
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
SecureStack C2 Configuration Guide 4-15
show lldp