Clear Multiauth Idle-Timeout; Show Multiauth Session-Timeout - Enterasys SecureStack C2 Configuration Manual

clear multiauth idle-timeout

Use this command to reset the maximum number of consecutive seconds an authenticated session
may be idle before termination of the session to its default value of 0.
Syntax
clear multiauth idle-timeout [dot1x | mac | pwa]
Parameters
dot1x
mac
pwa
Defaults
If no authentication method is specified, the idle timeout value is reset to its default value of 0 for
all authentication methods.
Mode
Switch mode, read‐write.
Example
This example resets the idle timeout value for all authentication methods to 0 seconds.
C2(su)->clear multiauth idle-timeout

show multiauth session-timeout

Use this command to display the session timeout value, in seconds, for all authentication methods.
Syntax
show multiauth session-timeout
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
(Optional) Specifies the IEEE 802.1X port‐based network access control
authentication method for which to reset the timeout value to its
default.
(Optional) Specifies the Enterasys MAC authentication method for
which to reset the timeout value to its default.
(Optional) Specifies the Enterasys Port Web Authentication method for
which to reset the timeout value to its default.
clear multiauth idle-timeout
SecureStack C2 Configuration Guide 18-39