Clear Maclock - Enterasys SecureStack C2 Configuration Manual

create
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
Configuring one or more ports for MAC locking requires globally enabling it on the switch first
using the set maclock enable command as described in "set maclock enable" on page 18‐49.
Example
This example shows how to create a MAC locking association between MAC address 0e‐03‐ef‐d8‐
44‐55 and port
C2(rw)->set maclock 0e-03-ef-d8-44-55 ge.3.2 create

clear maclock

Use this command to remove a static MAC address to port locking entry.
Syntax
clear maclock mac-address port-string
Parameters
mac‐address
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Usage
The MAC address that is cleared will no longer be able to communicate on the port unless the first
arrival limit has been set to a value greater than 0 and this limit has not yet been met.
For example, if user B's MAC is removed from the static MAC address list and the first arrival
limit has been set to 0, then user B will not be able to communicate on the port. If user A's MAC is
Establishes a MAC locking association between the specified MAC
address and port. Create automatically enables MAC locking between the
specified MAC address and port.
Enables or disables MAC locking between the specified MAC address and
port.
.3.2:
ge
Specifies the MAC address that will be removed from the list of static
MACs allowed to communicate on the port.
Specifies the port on which to clear the MAC address. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 5‐2.
SecureStack C2 Configuration Guide 18-51
clear maclock