Show Vlan Dynamicegress - Enterasys SecureStack C2 Configuration Manual

Parameters
vlan‐list
port‐string
forbidden
Defaults
If forbidden is not specified, tagged and untagged settings will be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to remove
C2(su)->clear vlan egress 9 ge.3.14
This example shows how to remove all Gigabit Ethernet ports in slot 2 from the egress list of
VLAN 4:
C2(su)->clear vlan egress 4 ge.2.*

show vlan dynamicegress

Use this command to display the status of dynamic egress (enabled or disabled) for one or more
VLANs.
Syntax
show vlan dynamicegress [vlan-list]
Parameters
vlan‐list
Defaults
If vlan‐list is not specified, the dynamic egress status for all VLANs will be displayed.
Mode
Switch command, read‐write.
Example
This example shows how to display the dynamic egress status for VLANs 50‐55:
C2(rw)->show vlan dynamicegress 50-55
VLAN 50 is disabled
Specifies the number of the VLAN from which a port(s) will be removed
from the egress list.
Specifies one or more ports to be removed from the VLAN egress list of the
specified vlan‐list. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 5‐2.
(Optional) Clears the forbidden setting from the specified port(s) and resets
the port(s) as able to egress frames if so configured by either static or
dynamic means.
.3.14 from the egress list of VLAN 9:
ge
(Optional) Displays dynamic egress status for specific VLAN(s).
show vlan dynamicegress
SecureStack C2 Configuration Guide 8-15