Clear Policy Port; Configuring Policy Class Of Service (Cos); Using Port-Based Or Policy-Based Cos Settings - Enterasys SecureStack C2 Configuration Manual

Example
This example shows how to allow Gigabit Ethernet ports 5 through 15 in slot 1 to transmit frames
according to policy profile 1:
C2(su)->set policy port ge.1.5-15 1

clear policy port

Use this command to remove a policy profile from one or more ports.
Syntax
clear policy port port-string profile-index
Parameters
port‐string
profile‐index
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove policy profile 10 from port 21 in slot 1:
C2(rw)->clear policy port ge.1.21 10

Configuring Policy Class of Service (CoS)

Using Port-Based or Policy-Based CoS Settings

The SecureStack C2 supports Class of Service (CoS), which allows you to assign mission‐critical
data to a higher priority through the device by delaying less critical traffic during periods of
congestion. The higher priority traffic going through the device is serviced first (before lower
priority traffic). The Class of Service capability of the device is implemented by a priority
queueing mechanism. Class of Service is based on the IEEE 802.1D (802.1p) standard specification,
and allows you to define eight priorities (0‐7, with 7 granted highest priority) and up to 8 transmit
queues (0‐7) for each port.
Specifies the port(s) from which to remove the policy profile. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.
Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile‐index value assigned using the
set policy profile command ("set policy profile" on page 9‐3) in order for
a policy profile to be active on the specified port.
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy-based CoS on the switches.
clear policy port
SecureStack C2 Configuration Guide 9-15